No puede abrir archivos .dwg de autocad

Discusiones generales sobre informática, sistemas informáticos, definiciones, investigación...

Moderador: alegsa

Mensajes: 2
Registrado: Dom Jun 28, 2015 8:20 am

No puede abrir archivos .dwg de autocad

Mensaje por tajoclaros » Dom Jun 28, 2015 8:36 am

No puedo abrir dibujo tengo mensaje en pantalla ERROR INTERNO: !dbqspace.h@410: eUnknownHandle ¿cómo puedo solucionar esta problema

Mensajes: 2
Registrado: Dom Jun 28, 2015 12:39 pm

Re: No puede abrir archivos .dwg de autocad

Mensaje por chanopita » Dom Jun 28, 2015 1:04 pm

Chicos. He encontrado la resolucion en este sitio magnifico.
DWG Repair Toolbox
First, open a blank DWG and run the RECOVER command. You can then browse to the problematic file, and AutoCAD will attempt to repair any errors it finds. Save the file, and then see if everything works as you expect it to. If not, continue on to the steps below:
1) Open the problematic file and make sure all layers are on and thawed.
2) Detach any XREF's.
3) Type in -PURGE at the command line (remember to enter the dash before the command). Type R for RegApps. Delete all RegApps in the file. It is not necessary to do them one by one because sometimes there can be thousands and it would take a very long time.
4) Type AUDIT, and select Y for yes to audit the file of any errors.
5) Type PURGE and purge the file of anything that can be purged.
6) Using the WBLOCK command, block out all the information in the file to create a new drawing. Select the objects by windowing them; do not just type ALL.
7) Open a blank DWG. Do not use any templates. (Set the STARTUP variable to 0, and then open a file if you are unsure if you are using templates)
8) Using the INSERT command, insert the file created in step 6.
9) EXPLODE the newly inserted information so it is not a block any longer.
10) Test to see if the file now works correctly. If it does, you can start to add in the Xref's again one by one. Test the file after each insertion. If the problem returns after inserting an Xref, you'll know that that file needs to be cleaned using these steps as well.
As a final note, I highly recommend running the AUDIT and PURGE commands before each save. This will keep the file clean and greatly reduce the chance of any corruption setting in. You too can have clean files by following these steps!


¿Quién está conectado?

Usuarios navegando por este Foro: No hay usuarios registrados visitando el Foro y 1 invitado